Light gray metal aggregate

Light gray metal aggregate

Light gray metal aggregate Product Overview:

The Light Gray Emery Floor is suitable for warehouses, underground parking lots, machinery manufacturing plants and Other places where the ground cannot be sand and dust, and can withstand the rolling of various vehicles (such as cars, forklifts, carts, etc.), so these The floor of the site must not only have the flat and smooth decorative effect of the general floor protection system, but also have strong wear resistance and pressure resistance. Therefore, the corundum wear-resistant floor is a floor system that professionally solves the ground protection problems of heavy machinery manufacturing plants, industrial and commercial warehouses, underground parking lots and other ground protection issues.Hard Acrylic Courts,Green Hard Acrylic Paint.

Light Gray Emery Material Applicable place:

Grounds for special places such as supermarkets, buildings, warehouses, auto showrooms, auto repair shops, and underground parking lots;

Areas with high mechanical performance requirements, ground with a certain impact on machinery, electronics, electrical appliances, instruments, medicine, textiles, clothing, food, tobacco and other corporate plants. Industrial plants, production workshops, warehouses, logistics centers, garages, parking lots, supermarkets, etc.White Hard Acrylic Paint,Red Hard Acrylic Paint.

Light Gray Silicon Carbide Floor Product Features:

Impact resistance, heavy pressure resistance, good mechanical properties;
Dustproof, mildewproof, wear resistant, good hardness;
Heavy pressure resistance, strong abrasion resistance, no dust, enhanced ground oil resistance, resistance to penetration;
The appearance is smooth, bright and diverse;

Easy to clean and easy to maintain.Concrete Seal Curing Agent.

Metal Floor Hardener Basic requirements:

The concrete strength of the grass-roots level shall be above C25, the water-cement ratio shall be controlled below 0.50, the concrete fall-out difference shall be controlled within 70-100mm, the concrete mixture shall minimize segregation and control the bleeding; in order to ensure adequate flow of the concrete mixture Sex and construction are conducive to construction, it is recommended that concrete be added with proper additives. Grass-roots concrete should be poured and tamped with reference to the standard of fine concrete, pay attention to the size and reduce laitance production. The hardener surface is constructed simultaneously with the concrete structure layer. If the same leveling layer is to be applied at the same time, it is recommended that the leveling concrete should be fine stone concrete with a thickness of not less than 50mm. Consider configuring the telescopic reinforcement mesh with special attention to the corners of the concrete construction block. Ensure that the concrete in the area is vibrated and compacted and additional strengthening measures should be taken.

Construction process:

Surface treatment: Use a mechanical rake with a disc to evenly remove the laitance layer on the concrete surface; first spread the diamond wear-resistant flooring material: spread the prescribed amount of 2/3 hardened wear-resistant flooring material evenly on the surface. After the concrete surface of the initial coagulation stage, it is polished with a low-speed screeding machine;

Scratch ruler leveling: Use a 6m scraper to evenly and horizontally erase and rough level the corundum wear-resistant flooring material; second time spread material: uniformly spread the specified amount of 1/3 color diamond abrasive wear-resistant flooring material. (After passing through the surface of the first ground diamond abrasive wear-resistant floor material), it is polished again with a trowel; surface polishing: according to the hardening of the concrete, the angle of the upper blade of the polishing machine is adjusted, and the surface polishing operation is performed to ensure the surface flatness. Smooth finish; base surface expansion: Emery wear-resistant floor should be maintained on the surface within 4 to 6 hours after the completion of the construction to prevent the rapid evaporation of surface moisture and ensure a steady increase in the strength of the diamond abrasion resistant floor.

Contact us if you need more details on Light Gray Emery Material. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Light Gray Emery Floor、Light Gray Silicon Carbide Floor. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Ground hardener system > Metal Floor Hardener